Table of Contents
Advertisement
Using the wired remote control
When using the steering wheel remote
control
Installation of the connection cable RC-SR1 (not
supplied) is required before use.
1
To enable the steering wheel remote control,
select [STEERING] [EDIT CUSTOM] to make the
registration.
When the registration completes, the steering wheel
remote control becomes available.
Notes on installing the connection cable RC-SR1 (not
supplied)
Refer to the support sites on the back cover for
details, then connect each lead properly to the
appropriate leads. Making an improper connection
may damage the unit.
Depending on the type of car, be sure to insulate the
unused leads with electrical tape for safety.
Do not connect this cable when the steering wheel
remote control is not used.
Consulting the dealer or an experienced technician
for help is recommended.
When using the wired remote control
1
To enable the wired remote control, set [STRG
CTRL] in [STEERING] to [PRESET].
14
GB
Installation
Mounting the unit in the dashboard
For Japanese cars, see "Mounting the unit in a
Japanese car" (page 15).
CAUTION
Do not touch the left side of the unit when
removing from the dashboard. The heatsink on
the left side of the unit remains hot right after
use.
Mounting the unit with an installation kit
(not supplied)
You can use a commercially available double DIN
installation kit. Choose an installation kit with the
following panel frame size.
Larger than 172 mm × 97 mm (6
h), with an inner corner radius of less than 0.5 mm
(
1
/
in).
32
Note
Be sure to use the mounting screws .
Larger than
97 mm (3
7
/
in)
8
Larger than
172 mm (6
7
/
in)
8
Installation kit (not supplied)
7
7
/
in × 3
/
in) (w/
8
8
To dashboard/center console
Advertisement
Table of Contents
