How To Set Up The Incline Trainer - NordicTrack 9600 Incline Trainer Manual

H S
OW TO ET
Assembly requires two persons. Set the INCLINE TRAINER in a cleared area and remove all packing materials.
Do not dispose of the packing materials until assembly is completed. Assembly can be completed using the
included allen wrenches.
1. Slide the Right and Left Uprights (96, 107) onto the
brackets near the front of the Base Frame (52). Make
sure that the Uprights are on the correct sides; the
indicated holes must be facing the INCLINE
TRAINER.
Raise the Left Upright (107) until the lower hole in the
front of the Upright is aligned with the upper hole in the
bracket as shown. Thread an Upright Bolt (106) into the
Upright and the bracket. Do not fully tighten the
Upright Bolt yet.
Repeat this step with the Right Upright (96).
2. While a second person holds the Handrail (94) near the
Uprights (96, 107), feed the wires in both sides of the
Handrail down into the Uprights. Pull the ends of the
wires out of the lower ends of the Uprights and remove
the wire ties from the ends of the wires.
Finger tighten four Handrail Bolts (93) into the Handrail
(94) and the Uprights (96, 107) as shown. Be careful to
avoid pinching the wires in the Handrail.
Note: The CD Holder (143) and the Cup Holder (10) are
replaceable. If these parts become dislodged from the
Console (89), simply press them back into place.
3. Connect the Right Upright Wire Harness (105), the TV
Cable (33), and the Left Upright Wire Harness (131) in
the indicated locations. The connectors should slide
together easily and snap into place. If they do not, turn
a connector and try again. IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS TURNED ON.
Push all of the excess wire up into the Uprights (96,
107). Make sure that all wires are fully connected.
Note: Regardless of which console your INCLINE
TRAINER has, connect all wires so that the console
can later be upgraded if desired.
Refer to step 1. While a second person holds the
Uprights (96, 107), remove the Upright Bolts (106). Slide
the Uprights fully onto the Base Frame (52). Be careful
to avoid pinching your hands or the wires.
U I
P THE NCLINE
T
RAINER
1
106
52
2
143
93
94
96
3
105
7
96
107
Holes
106
89
93
Wires
107
96
107
33 131
52
10