Steps For Operating For R-21Ltf/Lvf; Before Operation; Memory Operation; Cooking With Memory - Sharp R-21LCFS Operation Manual

STEPS FOR OPERATING FOR R-21LTF, R-21LVF

BEFORE OPERATION

* Before operating your new oven, make sure you
read and understand this operation manual com-
pletely.
1) Plug in the oven.
The digital display will then show
2) You can input the pads only when the door is
closed.
3) Oven light will come on when the oven is operating
or the door is open.

MEMORY OPERATION

The R-21LTF model has 20 and R-21LVF has 10
memory banks which can store cooking programs.
The first ten memory banks have been programmed
previously as follows, but they can be changed. See
page 9.
Memory No. Cook Time
1 10 sec.
2 20 sec.
30 sec.
3
4 45 sec.
5 1 min.
6 1 min. 15 sec.
7 1 min. 30 sec.
2 min.
8
9 2 min. 30 sec.
3 min.
0
Information in these memory banks is not lost due to
power interruptions. If the power goes off, the oven
does not need to be reprogrammed. No batteries are
necessary for this type of memory.

Cooking with memory

* Suppose you want to cook by using memory 1,
which was programmed for 10 seconds at 100%.
Procedure
1
1 Place food in oven.
Touch number pad.
.
Output Power
100%
100%
100%
100%
100%
100%
100%
100%
100%
100%
Display
NO.
After about 1 sec.
ON
8
4) The program and the check are canceled when
any pads are not touched for more than 3
minutes.
5) During cooking, except memory cooking, the
oven stops when the door is opened, and the
program is canceled if the START pad is not
touched within 1 minute after the door is closed.
6) The cooking is canceled when the door is
opened during memory cooking.
Cooking double quantity
with memory
Double quantity means the best time for cooking two
servings or twice the amount programmed in the
memory pad; it is not double the time.
* Suppose you want to cook 2 servings by memory
number 1.
Procedure
DOUBLE
QUANTITY
1 Place food in oven.
Touch DOUBLE
QUANTITY pad.
1
2 Touch number pad.
Note: The "MEMORY" cooking system does not
require the use of the START pad. Memory
pad cannot be used to start the oven if any
program is on display.
If the door is opened during memory cooking,
the program is canceled. To stop the cooking
of a memory pad and then restart, first, touch
the STOP/CLEAR pad, then open the door,
check food, close door and touch START.
If your programmed time is over maximum
time at Double Quantity, you cannot use
Double Quantity for the memory. You can
cook only 1 serving. See page 11.
Note: (For R-21LTF)
If you want to cook by using memory 11-20,
touch the desired number pad twice within 1
second.
Display
NO. X2
NO. X2
After about 1 sec.
ON X2