Table of Contents
Advertisement
CD OR CD+G OPERATION
PROGRAM
!
Use this button to program and play back songs in a preselected order.
!
Step 1: Programming should be done in the stop mode only.
Here "
XX
" stands for the total number of tracks, and it is blinking on the display.
!
Step 2: Press the SKIP buttons (
!
Step 3: Press PROGRAM button to confirm entry. You can repeat the same steps up to a maximum of 24 tracks.
!
Step 4: Press PLAY button when you have completed programming and you are ready to start singing.
!
Press the STOP button twice to clear all the programmed entries.
MONITOR ON/OFF
!
Press MONITOR ON/OFF button to ON if you want to display a CDG lyrics on the Singing Machine's
monitor.
KARAOKE FUNCTIONS
Sing along with the music by plugging in the provided microphone into either one of the microphone jacks on the unit.
D
Warning - Tapping or dropping the microphone while it is on can permanently damage your microphone. Resist
the urge to swing the microphone around by the cord!
MIC VOLUME
Adjust the MIC VOLUME control to a desired level and obtain the best performance.
D
Warning - To avoid Microphone feedback please avoid being too close to the speaker.
ECHO
Adjust the ECHO control to enhance your voice for a concert hall effect.
BALANCE
Adjust the BALANCE control to separate the prerecorded singer's voice and music when using a multiplex karaoke disc.
AUTO VOICE CONTROL
AUTO VOICE CONTROL can be activated by rotating the Auto Voice Control knob to right. The vocals on the multiplex
recording will be muted when using the microphone When the microphone is not in use the pre-recorded vocals will
resume on a multiplex disc.
BLUETOOTH OPERATION
Press the CDG/BT Button to switch to Bluetooth mode, "BLUE TOOTH" will appear on display and the PAIR indicator
flashes, after a few seconds, a sound will be heard, now it is in pairing and searching mode, start the Bluetooth function
on the external device, the pairing name "Singing Machine" will appear, select it and make pairing, the unit will send a
piece of sound, the "PAIR" indicator stop blinking after
During playing, press the NEXT or PREVIOUS button to skip to the track desired, press PLAY/PAUSE button to pause,
press again to resume. Press PAIR button to disconnect the current connection, press again to reconnect again.
NOTE: The unit will automatically connect with the device connected before after the Bluetooth function is switched on.
Press the PROGRAM button, PROG SET
- SKIP -
) to select a desired track.
(MULTIPLEX DISCS ONLY)
.
successful connection.
E8
00 XX
:
Advertisement
Table of Contents
