Use The Setup Menus To Enter Transducer Information; Calibrate The Transducer To The Input Channel; The Sc Series Instrument Is Ready For Use - Honeywell SC500 Manual

2.4 Use the SETUP Menus to Enter Transducer Information

2.5 Calibrate the Transducer to the Input Channel

2.6 The SC Series Instrument is Ready for Use

You can skip this step if:
• You are using a transducer equipped with Signature Calibration, or
• The transducer and instrument were purchased together and set up by Sen-
sotec.
Otherwise, you must enter information about your transducer into the SETUP
menu of the channel to which it is connected. See the appropriate chapter of this
manual for that card type.
You can skip this step if:
• You are using a transducer equipped with Signature Calibration, or
• The transducer and instrument were purchased together and set up by Sen-
sotec.
Otherwise, you must choose a calibration method (e.g. Shunt Calibration, mV/V
Calibration, or Known Load Calibration) appropriate for your application and use
the SETUP menu for the Input Channel ("
to the transducer. See the appropriate chapter of this manual for the input chan-
nel type that was purchased with the instrument.
See "RUN Mode" on page 20 for information on how to operate the instrument
while it is in the RUN mode.
Apply some test stimulus on the transducer to observe changes in the display.
SC Series Instruction Manual - Model SC500
") to calibrate the channel
CHANNEL 01 MENU
page 17