Activate Your Philips Wireless Hd Net Connect And Set Up The Link; Turn On The Power Of Your Hdtv; Activate The Wireless Link - Philips SWW1890/12 User Manual

5 Activate your
Philips Wireless
HD Net
Connect and set
up the link
Turn on the power of your
HDTV
HDMI
HDMI
1
Go to the source menu under the settings
menu of your HDTV.
2
Select the HDMI input to which the
receiver is connected.

Activate the wireless link

Switch on the transmitter and
receiver
When there is power supply for the transmitter
and receiver, they are on automatically.
» The link between the transmitter and
receiver is established.
.
Establish the link between the
transmitter and receiver
• A flashing blue power LED is displayed
until the signal link between the two units
is established. Normally, it takes around
15-20 seconds for the link to establish
successfully.
• When you unplug the power cord of the
transmitter, the receiver enters standby
mode after 5 minutes.
» The power LED of the receiver lights
up in red.
• The link between the transmitter and
receiver re-established when you plug in
the power cord of the transmitter again.
» The power LED of the receiver flashes
in blue.
LED indicator status of the transmitter
Power LED indicator Status
Solid blue
Flashing blue
LED indicator status of the receiver
Power Status Mode and status
LED LED
Solid Off Standby mode for power-
red saving
Flashing Flashing Setting up a Link between
blue the transmitter and
receiver
Solid Flashing On mode but without
blue quickly input from the computer/
source device
Solid Flashing On mode with
blue slowly unrecognized video format
Solid Solid On mode with recognized
blue blue video format
The link is established.
Linking is in progress.
EN
9