Philips SLA500 User Manual page 33

Activating a New Profile on the SLA5500NS using Remote
Control
A 'default' network profile is loaded automatically when you first install the
SLA5500NS.
However, you may wish to activate an alternative network profile that you have
created using the Configuration Wizard or the Philips Wireless Music Receiver PC
Utility.
Follow these steps to activate a different network profile:
1 Press SYSTEM (6) on the remote control to display the Configuration menu.
2 Press 4 until 'Select Profile' is highlighted. Press 2.
3 A list of available profiles is displayed. The currently active profile is denoted by
an asterisk [*].
4 Press 4 to highlight the desired profile. Press 2.
5 The message 'Selected Profile N...Applying Settings' will be displayed.
After a few seconds, the SLA5500NS will restart. The device is now ready to
operate using the new profile.
Note: This function can also be performed using the Philips Wireless Music
Receiver PC Utility – see 'Activating a Different Network Profile'.
Editing the Device Name
Your SLA5500NS is given the default device name Philips SLA5500NS during initial
installation.
Follow these steps to change the device name of your SLA5500NS:
1 Press SYSTEM (6) on the remote control to display 'Configuration'.
2 Press 4 until 'Advanced Settings' is highlighted. Press 2.
3 Press 4 until 'Edit Device Name' is highlighted. Press 2.
4 Press 4 until 'Change' is highlighted. Press 2.
5 Edit the name of your SLA5500NS device (see 'Entering Text in Edit Mode').
Example: My SLA5500NS
6 Press 2 to complete the change.
Performing a Hard Reset to Factory Settings
Under normal circumstances, you should reset the SLA5500NS to its factory settings
by activating the Factory Default profile using the Philips Wireless Music Receiver PC
Utility (see 'Activating a Different Network Profile').
However, should this not be possible for some reason, you can perform a hard reset
on the SLA5500NS device itself, as follows:
1 Ensure that the SLA5500NS is turned on.
2 Insert a paperclip into the small reset hole and hold the reset button down for
2 seconds.
3 Remove the paperclip and wait until the SLA5500NS restarts.
EN
33