Electrolux EWF8042R7WB User Manual page 14

14 www.electrolux.com
Time Manager
This option allows you to adjust the wash
time. Press this touchpad repeatedly to
decrease or increase the wash time
according to the soil level of your wash.
Use the table below as a guide.
Light
Time Manager function is not
available when
Delay End (
Before you start the program, this option
makes it possible to define the end of the
washing program from minimum of 1 hour
to maximum of 20 hours.
If program duration is longer than
3 hours, minimum Delay End
option starts from 4 hours.
Press the Delay End touchpad to choose
the end time as you wish. The display
shows the number of hours and the
indicator beside the touchpad is on.
This option must be selected after
choosing the wash program, and
before pressing the "Start/Pause"
touchpad.
For example, if the program duration of
your selected program is 3.20 hours and
you define the "Delay End" time to 6
hours. This means your wash program
will finish in 6 hours. (See diagram)
Countdown
Pressed
Start/Pause
After selecting Delay End time, press
Start/Pause touchpad to start the
program. Machine will then countdown
and update time on the display every
hours until it reaches the starting point of
the wash cycle.
Soil Level
>> Medium >>
) Touchpad
"Delay End" Time : 6 hrs.
Working Cycle
2.40 hrs. 3.20 hrs.
Start the
Program
If you wish to modify or cancel Delay End
option after starting the program, follow
the steps below:
– set the washing machine to PAUSE by
pressing "Start/Pause" touchpad;
– deselect this option by pressing
"Delay End" touchpad repeatedly till
the display shows delay time "
Heavy
press the "Start/Pause" to start the
–
program.
is on.
Select "
the sensors for the dirt and detergent
residue.
When using this option, the washing
machine will automatically check the dirt
level and detergent residue* on your
laundry. The machine will automatically
adjust the washing time and numbers of
rinses according to the load to make sure
that your clothes are really clean.
* Only for liquid detergent
The SensorWash technology consist of 2
different sensors for detection:
1) The 1
dirt level at the start of cycle and
automatically calculates the actual
time needed to remove the level of dirt
in the wash; from low dirt levels all the
way to the maximum dirt level.
2) The 2
the amount of detergent residue after
the first rinse and the machine will
End of
calculate the optimum number of
Cycle
rinses (Maximum addition of 2 rinses)
needed to make sure that the
detergent residue is properly removed.
( ) Touchpad
" option to turn ON
st
Turbidity sensor detects the
The initial time displayed on the
control panel indicates the time
needed for the maximum dirt
level.
nd
Conductivity sensor will check
Please see details of detergent
usage at "Detergents Type and
Quantity of Detergent"
";