Table of Contents
Advertisement
Operation instruction
FAN ONLY OPERATION:
1)Start up operation: press the button of ON/OFF,
the system will start up, and will display on
LCD.
2)Select MODE: press the MODE button, then
you will see in the display section [MODE]
switch over in below sequence:
[FAN ONLY]
[COOL]
[AUTO]
[FAN ONLY].
Select [FAN ONLY].
3)Select fan speed: press FAN button, then you
see in the display section [FAN] switch over in
below sequence: [HIGH]
[HIGH]. Select proper fan speed.
4)Power off: press ON/OFF button, indoor unit
will be powered off, there are only time and the
ambient temperature in the screen.
AUTO operation, COOLING, HEATING and DEHUMIDIFICATION operation
1) Start up operation: press the button of ON/OFF,
the system will start up, and will display on LCD.
2) Select MODE: press the MODE button, then you
will see in the display section [MODE] switch
over in below sequence:[FAN ONLY]
[DRY]
[HEAT]
3) Change set temperature: press TEMP + or ñ
every time, [SET] will display, and set temperature
will increase/reduce 1 C( F).
4) Select fan speed: press FAN button, then you see
in the display section [FAN] switch over in below
sequence: [HIGH]
[HIGH].Select proper fan speed.
5) Select [SWING]: press [SWING] button,
[SWING] will display, swing function is valid,
press again, [SWING] will disappear, swing
function is invalid.
6) Set [HEALTH]: used to set the indoor health function. Press it once, [HEALTH] will display in the
display section, then indoor health function is valid. Press it again, [HEALTH] will disappear, then the
health function is invalid.
This function is valid only for the unit with health function.
7) Power off: press ON/OFF button,indoor unit is powered off. There are only time and the ambient
temperature in the screen.
[DRY]
[HEAT]
[MED]
[LOW]
[COOL]
[AUTO]
[FAN ONLY].
[MED]
[LOW]
C
C
8
Wired controller
HEALTH
SET
RECOVERY
CHECK
HEALTH
SET
RECOVERY
CHECK
2
3
1, 4
2
4
5
3
6
1, 7
Advertisement
Table of Contents
