Advertisement
15
HEALTH Button
Feature not available on this series.
16
Function: Setting and canceling timer and other functions.
17
LOCK Button
Used to lock buttons and LCD display
18
LIGHT Button
Turns indoor unit display on and o
19
RESET Button
If the remote control is not functioning properly, use a pen
point or similar object to depress this button to reset the
remote.
Emergency Operation
Emergency Operation:
Use this operation only when the remote control is defec-
tive or lost.
When the emergency operation switch is pressed, the unit
beeps once, which indicates the start of this operation.
When the power switch is turned on for the rst time and
emergency operation starts, the unit will run automatically
in the following modes:
Room
Timer
Designated
temperature
mode
temperature
o
o
Above 73
F
79
F
No
o
o
Below 73
F
73
F
No
During emergency operation, it is not possible to change
the settings of temperature and fan speed. It is also not
possible to operate in timer or dry modes.
Inserting the Batteries
1.
Remove the battery cover
2.
Insert 2 AAA batteries as
illustrated noting battery polarity
3.
Reinstall the battery cover
NOTE:
The distance from the remote
control to the receiver should
be less than 23 feet with no
obstructions.
If the remote control display is weak or the operating
distance has diminished, the batteries may need to be
replaced.
Remote control malfunctions can sometimes be corrected
by removing the batteries from the remote for a few min-
utes and then reinstalling them.
Remove the batteries from the remote control if the unit
will not be in use for an e tended period of time. If any seg-
ments of the display remain active after battery removal,
press the reset button.
Fan
Operation
emergency
operation switch
speed
mode
AUTO
COOL
AUTO
HEAT
EMERGENCY OPERATION & MAINTENANCE
CONTROLLER FEATURES & SETTINGS
Optimizing Performance
Close doors and windows
during operation
During cooling operation
prevent direct sunlight
with curtains or blinds
Wipe the air conditioner using a soft and
dry cloth. For serious stains, use a neutral
detergent diluted with water. Wring the water
out of the cloth before wiping down the unit.
Then wipe o the detergent completely.
Cleaning the Air Filter
1. Open the inlet grille by pulling
it upward
2. Remove the lter.
downward.
3. Clean the lter.
Use a vacuum cleaner to remove
completely.
4. Attach the lter
not attached correctly the unit may
5. Close the inlet grille.
Do not block the air inlet
or outlet
Once every
two months
PAGE 5
Advertisement
