Creating A Vertex By Entering The Position - JRC JMR-5406-X Instruction Manual

10.6.2.1 Creating a vertex by entering the position

1
Click on the [Enter POSN] button on the drawing toolbar.
The [Enter Position] dialogue appears.
2
Enter the values of latitude and longitude of the vertex of the object in the [Position]
box and click on the [Enter] button.
The position of the vertex of the object is determined.
The [Bearing] box and the [Distance] box are enabled.
3
Enter the values of the latitude and the longitude of the next vertex in the [Position]
box. Alternatively, enter the bearing from the vertex that was determined immediately
previously in the [Bearing] box and the [Distance] input box.
4
Click on the [Enter] button.
5
Adjust the parameters on the object property dialogue.
6
To create an object in another position continuously, click on the [New] button of the
[Enter Position] dialogue and repeat Steps from 2 to 5.
Section 10 Creating a User Map 10-18