Table of Contents
Advertisement
Chapter 4. Remote control
Auto Turn Off
Setting an Anynet+ Device to turn Off automatically when the product is turned off.
• If Auto Turn Off is set to Yes, running external devices will turn off at the same time
as the product powers off.
• May not be enabled depending on the device.
Search for Devices
Switching between Anynet+ devices
1
Press the
button, select
Anynet+
TOOLS
2
Select
Select
Device, and then press the
If you cannot find a device you want, select
3
Select a device, and then press the
device.
• The
Select Device
menu appears only when you set
in the
System
menu.
• Switching to the selected device may take up to 2 minutes. You cannot cancel
the switching operation while switching is in progress.
• If you have selected an Anynet+ device by pressing the
selecting its input source, you cannot use the
• Make sure to switch to an
Anynet+
(HDMI-CEC), and then press
.
button.
Refresh
to refresh the list.
button. You can switch to the selected
Anynet+ (HDMI-CEC)
button and then
SOURCE
Anynet+
function.
device by using the
Select
Device.
Troubleshooting for Anynet+
Problem
Anynet+ does not
work.
to
On
I want to start
Anynet+.
I want to exit Anynet+.
Possible Solution
• Check if the device is an Anynet+ device. The Anynet+
system supports Anynet+ devices only.
• Check if the Anynet+ device power cord is properly
connected.
• Check the Anynet+ device's Video/Audio/HDMI cable
connections.
• Check whether
Anynet+ (HDMI-CEC)
System
menu.
• Check whether the remote control is Anynet+
compatible.
• Anynet+ doesn't work in certain situations. (initial
setup)
• If you have removed and then reconnected the HDMI
cable, please make sure to search devices again or turn
your
• product off and on again.
• Check if the Anynet+ function of the Anynet device is
set on.
• Check if the Anynet+ device is properly connected to
the product and check if the
Anynet+ (HDMI-CEC)
to
On
in the
System
menu.
• Press the
button to display the Anynet+ menu
TOOLS
and select a menu you want.
•
Select View PC
in the
Anynet+
menu.
• Press the
button on the product remote control
SOURCE
and select a non- Anynet+ device.
81
is set to
On
in the
is set
Advertisement
Table of Contents
