Table of Contents
Advertisement
Cleaning and maintenance
en
The drain hose at the siphon
is blocked
Switch off the appliance. Pull out the
1.
mains plug.
Loosen the hose clamp. Carefully
2.
remove the drain hose, residual
water may leak out.
Clean the drain hose and siphon
3.
connecting piece.
Reattach the drain hose and secure
4.
the connection point using the hose
clamp.
22
Filter in the water supply
blocked
:
Warning
Risk of electric shock!
Do not immerse the Aqua-Stop safety
valve in water (it contains an electric
valve).
First, reduce the water pressure in the
supply hose:
Turn off the tap.
1.
Select any programme (except
2.
Rinse / Spin / Drain/Empty).
Select Start/Pause. Allow the
3.
programme to run for approximately
40 seconds.
Turn the programme selector to Off.
4.
Pull out the mains plug.
Clean the filter on the tap:
5.
Disconnect the hose from the tap.
Clean the filter with a small brush.
For standard and Aqua-Secure
6.
models, clean the filter on the rear of
the appliance:
Remove the hose from the rear of
the appliance.
Use pliers to remove the filter and
then clean it.
Connect the hose and check for
7.
leaks.
Advertisement
Table of Contents
