Altec Lansing MZX856 Quick Start Manual

1. Make sure the following items are
included in your package.
USB Cable
Ear Caps MZX856 In-Ear
Sport Headhones
4. Powering ON/Powering OFF Your Headphones:
-Press and hold the Power button for approximately three seconds to power on
your headphones. Your headphones will automatically connect with the last phone
they were paired with.
-Once powered on, you can press and hold
the Power button again for approximately
three seconds to power o your headphones.
The LED Indicator light will briefly turn red
before powering o .
NOTE: In order to save power, your headphones
will automatically power o if left unpaired and idle
for over ten minutes.
6. Wearing Your Headphones
For the best sound performance and a secure, comfortable fit, be sure that the
ear buds rest gently in your ear and drape around the back of your neck. Use the
ear cap that works best for you.
2. For a look at the various buttons and parts of your headphones,
view the graphic below.
1. Earloop
2. Free Bit Ear Tips
3. Volume Up/Next Track
4. Power/Answer/Pairing
5. Volume Down/Previous Track
6. Charging Port
7. Microphone
8. LED Indicator Light
5. Pairing Your Headphones With a Bluetooth Phone
-Press and hold the Power button for around five seconds. When your speaker
is ready to pair with a Bluetooth audio source, it will go into pairing mode,
with red and blue LED lights will flash alternately.
-Go to the Bluetooth Manager of your Bluetooth device. Search
Bluetooth devices and select "Altec BT Sport" to start connecting.
3 Seconds
-If required, enter the PIN code "0000" and confirm the entry.
Once paired, you will hear your speaker audibly say: "You are
now paired, enjoy."
7. Listening to Music
Play/Pause
Press the Power button to get music from your audio source to play or pause.
Next/Previous Song
Press and hold the Volume Up or Volume
Down buttons for two seconds to advance to
the next song or go back to the previous one.
Increase/Decrease Volume
Press and hold the Volume Up or Volume
Down buttons to increase or decrease the
volume.
NOTE: Music will automatically pause when
a call is dialed out or when there is an incoming
call. It will resume when the call ends.
Quick Start Guide
3. Charging: When charging, a red LED light will illuminate. The light will turn o
when your unit is fully charged. Your headphones can take up to one hour to fully
charge.
1
2
3
4
5
6
7
8
8. Using Your Headphones During Phone Calls
Last Number Redialing
Quickly tap on the Answer button twice and the last number that you dialed will be
redialed.
Answering an Incoming Call
To answer an incoming call, quickly
press the Answer button.
Ending a Call
To end a call, quickly press the Answer
button, and the call will be disconnected.
Adjusting Volume
By pressing the Volume Up or Volume
Down buttons you can increase or decrease
the volume of the phone call.
.
Altec BT Sport