Altec Lansing MZW300 Quick Start Manual

BLUETOOTH
1. Make sure the following items are
included in your package.
USB Cable MZW300 Headhones
4. Power ON/Power OFF Your Headphones:
-Press and hold the Power button for approximately three seconds to power
on your headphones. Your headphones will automatically connect with the
last phone they were paired with.
-Once powered on, you can press and hold the
Power button again for approximately five
seconds to power o your headphones. The
LED Indicator light will briefly turn red before
powering o .
NOTE: In order to save power, your
headphones will automatically
power o if left unpaired and idle for
over two minutes.
6. Listening to Music
Play/Pause
Press the Power button to get music from your audio source to play or pause.
Next/Previous Song
Press and hold the Volume Up or Volume
Down buttons for two seconds to advance to
the next song or go back to the previous one.
Increase/Decrease Volume
Press the Volume Up or Volume
Down buttons to increase or decrease the
volume.
NOTE: Music will automatically pause when
a call is dialed out or when there is
an incoming call. It will resume when
the call ends.
2. For a look at the various buttons and parts of your headphones,
view the graphic below.
Indicator
Volume Up/NEXT
Volume Down/Previous
Power/play/Answer
5. Pairing Your Headphones With a Bluetooth Phone
-Press and hold the Power button for around five seconds. When your
headphone is ready to pair with a Bluetooth audio source, it will go
into pairing mode, with red and blue LED lights will flash alternately.
-Go to the Bluetooth Manager of your Bluetooth device. Search
Bluetooth devices and select "Altec Over ear BT" to start connecting.
-If required, enter the PIN code "0000" and confirm the entry. Once
3 Seconds
paired, the headphone will connect to your Bluetooth device
automatically.
7. Using Your Headphones During Phone Calls
Last Number Redialing
Quickly tap on the Answer button twice and the last
number that you dialed will be redialed.
Answering an Incoming Call
To answer an incoming call, quickly press the
Answer button.
Ending a Call
To end a call, quickly press the Answer
button, and the call will be disconnected.
Adjusting Volume
By pressing the Volume Up or Volume
Down buttons you can increase or
decrease the volume of the phone call.
Quick Start Guide
Charging Port
Auxiliary Port
Microphone
3. Charging: When charging, a red LED light will illuminate. The light will turn blue
when your unit is fully charged. Your headphones can take up to two
hours to fully charge.
Bluetooth
Devices
5 Seconds
Altec Over ear BT
Now discoverable
Important Note
You can also use the 3.5mm Audio Cable to connect audio devices through the
Auxilliary Port on your headphones.
Note that when using the Audio cable instead of the standard wireless Bluetooth
connection, the Volume Up, Volume Down and Play/Pause buttons do not function.
Please use your audio source to control these functions.
Technical Support
For technical support issues please visit our website at www.alteclansing.com.
You can find manuals and FAQ's at the website. Can't find what you are
looking for? Call 1-855-292-4087 to access our technical support information
on the phone.
12:12 PM
Bluetooth
ON
Paired