WIRELESS
1. Make sure the following items are
included in your package.
USB Cable
Middle
Large
Small
Ear Caps
(three sizes for maximum comfort)
4. Power ON/Power OFF Your Headphones:
-Press and hold the Power button for approximately three seconds to power
on your headphones. Your headphones will automatically connect with the
last phone they were paired with.
-Once powered on, you can press and hold the
Power button again for approximately five
seconds to power o your headphones. The
LED Indicator light will briefly turn red before
powering o .
NOTE: To conserve power, the headphone
will turn o automatically if it's not
connected to a device over 10
minutes.
6. Wearing Your Headphones
For the best sound performance and a secure, comfortable fit, be sure that
the ear buds rest gently in your ear and drape around the back of your neck.
Note that the included ear caps come in three di erent sizes. Use the ear
cap that feels most comfortable in your ear.
2. For a look at the various buttons and parts of your headphones,
view the graphic below.
MZW100
Stereo Earphones
5. Pairing Your Headphones With a Bluetooth Phone
-Press the Power button for around five seconds. When your
headphone is ready to pair with a Bluetooth audio source, it will go
into pairing mode, with red and blue LED lights will flash alternately.
-Go to the Bluetooth Manager of your Bluetooth device. Search
Bluetooth devices and select "Altec In-ear BT" to start connecting.
-If required, enter the PIN code "0000" and confirm the entry. Once
paired, the headphone will connect to your Bluetooth device
3 Seconds
automatically.
7. Listening to Music
Play/Pause
Press the Power button to get music from your audio source to play or pause.
Next/Previous Song
Press and hold the Volume Up or Volume
Down buttons for two seconds to advance to
the next song or go back to the previous one.
Increase/Decrease Volume
Press the Volume Up or Volume
Down buttons to increase or decrease the
volume.
NOTE: Music will automatically pause when
a call is dialed out or when there is
an incoming call. It will resume when
the call ends.
Quick Start Guide
Ear Cap
Volume Up/Next
Power/play/Answer
Volume Down/Previous
Charging Port
Microphone
LED
3. Charging: When charging, a red LED light will illuminate. The light will turn blue
when your unit is fully charged. Your headphones can take up to two
hours to fully charge.
Indicater
Bluetooth
5 Seconds
Devices
Altec In-ear BT
8. Using Your Headphones During Phone Calls
Last Number Redialing
Quickly tap on the Answer button twice and the last
number that you dialed will be redialed.
Answering an Incoming Call
To answer an incoming call, quickly press the
Answer button.
Ending a Call
To end a call, quickly press the Answer
button, and the call will be disconnected.
Adjusting Volume
By pressing the Volume Up or Volume
Down buttons you can increase or
decrease the volume of the phone call.
12:12 PM
Bluetooth
ON
Paired
Now discoverable