Advertisement
1. When the DTMF code is transmitted using the auto dialer, the code is transmitted
with programmed burst/ pause time. The initial setting is 60ms.
DTMF first digit's burst time
2. When the DTMF code is transmitted using the auto dialer, the code will be
transmitted at the programmed first digit burst time. The initial setting is 60ms.
3. WAIT time cannot be changed while CH is displayed.
6-10 Alphanumeric Function
In the memory mode this function allows to display optional alphabet, number or code
instead of frequency.
Alphanumeric function setting
1. In memory mode select the desired channel.
2. Press and hold the F key, then press the D/NAME key while F icon is ON.
3. Flashing [A ] will appear on the LCD.
4. Rotate the dial to select the desired letter.
5. Press [D] key, the flashing will be stopped indicating the letter is stored.
6. The same letter flashes on the right of the stored letter waiting to be stored.
7. Press the [D] key to store in the memory. (Store desired letters in turn.)
8. If you press the C key while storing, the stored letters will be erased.
9. Press the PTT key to complete the operation.
Operation of alphanumeric function
1. When the unit enters the memory mode, if the channel is programmed
alphanumeric function, the frequency display part will be showed with the stored
alphanumeric letters. (The CH number will be displayed as it was.)
Press F key, and the frequency will appear for 5 seconds on the LCD. (If any key is
pressed within 5 seconds, the LCD returns to the display with the alphanumeric
letters.)
6-11 TOT (Time Out Timer) Function
TOT setting
1. Press and hold the F key, then press the 3/TOT key while F icon is ON.
[T-OFF] will appear on the LCD.
2. The display is toggled as follows by dialing, and the setting of TOT will be changed.
3. The number indicated on *** is the current Time Out Time.
4. Change the TOT time by rotating the dial. The TOT time can be programmed up to
max. 450 seconds.
......downward upward .....
..... OFF..... 30 .....60 .....90 ...............450.....
...........................................................
Press any key (except for FUNC and MINI keys) to complete the setting. The
LCD will return to the ordinal mode.
Operation of TOT
1. If the continuous transmission time is over the programmed time, a beep sounds 5
seconds before the time is up. Then the transceiver enters the receiving mode
automatically.
2. In this case, unless the PTT key is turned OFF, the next transmission is deactivate.
(When the TOT Penalty is set, transmission can not be done even if you turn OFF
the PTT then ON again within the programmed time.)
Advertisement
