Table of Contents
Advertisement
„
„
MEMORY NAME (Alphanumeric Tag)
The memory channels stored in the memory-mode can be displayed with
an alphanumeric tag instead of the default frequency display. Program
the memory channel first.
There are 67 characters available including A-Z, 0-9.
1.
Rotate the push-button rotary knob or press the [UP]/[DOWN] keys
on the microphone to display the menu number "2".
2.
Select alphanumeric tag setting by rotating the main dial or press-
ing the [UP]/[DOWN] keys. The display shows [A] flashing.
3.
Rotate the main dial to select a character. Press the [V/M/MW] key.
The character stops flashing and is entered.
4.
The same flashing character appears next to it, ready for the next
character to be entered. Repeat the same sequence, up to seven
characters.
5.
To delete all characters during programming press [CALL/H/L] key.
6.
To exit after setting is done, press one of the following keys: [PTT],
[FUNC/SET], [TS / DCS].
After programming, the alphanumeric tag will be displayed on the
designated channels, instead of the frequency, when in memory
mode. The memory channel number and other status icons will
also be displayed. If you wish to see the programmed frequency,
press FUNC and it will be displayed for 5 seconds. To return to the
alphanumeric display, wait 5 seconds or press any key.
Pressing any key followed by FUNC returns to normal operation,
regardless of the display status.
This function cannot be enabled without programming the
IMPORTANT
memories.
PARAMETER SETTING MODE
„
„
MEMORY DISPLAY INDICATOR
Switch the frequency display and memory NAME display when a
memory name is registered using the memory NAME function.
1.
Rotate the push-button rotary knob or press the [UP]/[DOWN] keys
on the microphone to display the menu number "3".
The current setting will appear on the display.
The default setting is "FRQ" (frequency display).
2.
Rotate the push-button rotary knob or press the [UP]/[DOWN] keys
on the microphone to change the setting.
The options are as follows.
NM: Displays the memory name.
▼
FRQ: Displays the frequency.
▼
Pressing the [FUNC/SET] key when NM is selected displays the
frequency for 5 seconds.
3.
Press the push-button rotary knob.
The unit will go back to menu mode.
„
„
BEEP
Set whether or not to output the operation sound.
1.
Rotate the push-button rotary knob or press the [UP]/[DOWN] keys
on the microphone to display the menu number "4".
The current setting will appear on the display.
The default setting is "BEEPON".
2.
Rotate the push-button rotary knob or press the [UP]/[DOWN] keys
7
20
Advertisement
Table of Contents
