Table of Contents
Advertisement
The new squelch level will be stored in the CPU until another
adjustment is done.
„
„
To Receive Signals
1.
Press the PWR key.
2.
Rotate the VOL knob to set the volume to an adequate level.
3.
While the SQL indicator is displayed, press the [SQL / REV] key,
then keep rotating the knob until the noise disappears.
4.
Select your desired frequency.
When a signal is received at your desired frequency, [BUSY] will
light up and receiving sound will be heard.
The S-meter will swing according to the receiving signal strength.
„
„
Monitoring Function
This function allows you to cancel the squelch operation so that weak
signals that are below the operation level can be heard.
1.
Press and hold the [SQL / REV] key for 1 second or more.
[BUSY] will appear and the squelch operation will be canceled.
2.
To cancel the monitoring function, press any key on the unit except
for the knob.
The squelch operation will be activated again.
„
„
To Transmit Signals
1.
Select your desired frequency.
2.
Press the [PTT] key on the microphone.
The TX indicator lights red and the unit will be in transmission
mode.
Basic Operations
3.
While pressing the [PTT] key, speak into MIC in a normal voice.
Place the microphone about 5 cm away from your mouth when you
speak.
Release the [PTT] key to return to receiving mode.
Pressing the [PTT] and [DOWN] keys simultaneously will transmit a
tone call signal.
When the automatic dialer is set, pressing the [PTT] and [UP] keys
simultaneously will transmit the automatic dialer signal. (P.40)
If the [PTT] key is pressed outside of the transmission frequency
range, [OFF] will appear on the display. In this situation, signals
cannot be transmitted.
„
„
CALL mode
This is a memory mode that allows the transceiver to quickly recall
the assigned memory channel by simply pressing the [CALL/H/L] key,
regardless of the current status of the unit.
1.
Press [CALL/H/L] key. The [C] icon appears on the display and the
transceiver enters the CALL mode. In this mode, the main dial or
the [UP]/[DOWN] keys cannot change the frequency or memory
channels.
2.
Press [CALL/H/L] key again or press [V/M/MW] key to exit CALL
mode.
3.
No scan functions are available in CALL mode.
To store a desired setting in the CALL channel, follow the memory
mode programming instructions and assign your selected settings
to memory channel C. The call channel can be modified but cannot
be eliminated or hidden.
5
14
Advertisement
Table of Contents
