Kohler ESCALE K-25091T-S Installation Instructions Manual page 22

2. Make sure of h according to dimensions of bowl and then
locate the installation hole of fixing bracket. Mark on the
wall for appropriate position for fixing bracket, and drill four
holes with diameter of 10mm and depth of 80mm with
churn drilling as shown in illustration, and fill in the holes
with bulge screw and tighten the screw to set the fixing
bracket.
Note: Ensure the fixing bracket to remain level.
2.
10mm 80mm
O
3. Put the tank onto the fixing bracket as shown in the right
figure and adjust the tank to level . Then tighten screws
with hex-head key.
Note: it is a must to keep the tank level.
3.
4. Connect with overflow pipe on the side when installing
K-78073K-PNE/K-78075K-PNE.
4. K-78073K-PNE/K-78075K-PNE
5. Connect tap water braided tube on the top of water tank for
water supply as shown.
Note: 1. Ensure water tank internal valve is OFF.
2. Suggestion: connect a temporary rubber or plastic
hose on valve, flush water supply pipeline. Ensure
water is clean, no residual sand stone or fouling
inside pipeline.
5.
1.
2.
1288818-T01-B
h
-16-
h
Overflow Pipe
Connecting Pipe
Water Pipe
Bulge Screw
Fixing Bracket
Gasket
Spring
Nut
Level
Tank
Loosen
Tighten
Medium
Allen Key
Screw