Advertisement
camera operation
DaY/nighT : You can display pictures in color or in black and white.
❶
If the SPECIAL menu screen is displayed, use the Function Setup switch so
that the arrow indicates 'DAY/NIGHT'.
❷
Select a desired mode using the Function Setup switch according to the
picture display you want.
-
auTo : The mode is switched
BURST MODE : Activate or deactivate the burst mode to maintain or
DURATION : This function is used to select the brightness of light where
GAIN LEVEL
VERY SLOW
NORMAL
VERY FAST
※ Depending on the installation environment and the exposure menu's gain
mode setting, the switching brightness may vary.
DWELL TIME : You can select day/night switching delay time from.
M
If you set the AGC mode to off on the exposure menu, you cannot switch the day/night mode to auto.
When a bright light source is in the screen or there are frequent brightness changes, if you use the
auto night/day mode, and set the switching time to short (3, 5 sec), a hunting can be caused. In this
situation, it is recommended to use the default setting (30 sec).
-
COLOR : The picture is always displayed in color.
-
B/W : The picture is always displayed in black and white.
2_ camera operation
to 'Color' in a normal
environment, but
switches to 'B/W' mode
when ambient illumination
is low. To set up the
switching time for AUTO mode, press the Function Setup switch. You
can turn on or off the burst signal on B/W mode.
remove the color signal.
switching occurs.
LOW
Color → B/W B/W → Color Color → B/W B/W → Color Color → B/W B/W → Color
3.3
SLOW
3.4
3.5
FAST
3.6
3.7
→ 3s, 5s, 7s, 10s, 15s, 20s, 30s, 40s, 60s
The burst signal can be enabled or disabled with the 'burst ON/OFF' setting
in the sub menu.
BURST MODE
▶
1.
DURATION
2.
DWELL TIME
3.
RETURN
4.
MID
6.2
2
6.1
2.4
6
2.8
5.9
3.2
5.8
3.6
AUTO SETUP
<Unit: Lux>
HIGH
6.8
0.7
6.5
1.4
6.3
2.1
6.1
2.8
5.9
3.5
ON
NORMAL
30 SEC
7.5
7
6.6
6.3
6
Advertisement
