Table of Contents
Advertisement
1. Touch the Start/Pauze - Départ/
Pause button.
In the display the related door lock
indicator goes off.
2. Open the appliance door. If
necessary, add or remove the items.
3. Close the door and touch the Start/
Pauze - Départ/Pause button.
The programme or the delay start
continues.
4. The door can be opened when the
programme is complete, or set
spinning or draining programme/
option and than press Start/Pauze -
Départ/Pause button.
12.13 End of the programme
When the programme has finished, the
appliance stops automatically. The
acoustic signals operate (if they are
active).
In the display all washing phase
indicators become steady and the time
area shows .
The indicator of the Start/Pauze - Départ/
Pause button goes off.
The door unlocks and the indicator
goes off.
1. Press the Aan /Uit - Marche/Arrêt
button to deactivate the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
show the end of the last
selected programme. Turn
the programme dial to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door and the detergent
dispenser slightly ajar to prevent
mildew and odours.
5. Close the water tap.
12.14 Draining water out after
end of cycle
If you have chosen a programme or an
option that does not empty out the water
of the last rinse, the programme is
completed, but:
• The display shows the indicator , the
option indicator
door locked indicator
indicator of the running phase
flashes.
• The drum still turns at regular
intervals to prevent the creases in the
laundry.
• The door stays locked.
• You must drain the water to open the
door:
1. If necessary, touch the Centrif. -
Essorage button to decrease the spin
speed proposed by the appliance.
2. Touch the Start/Pauze - Départ/
Pause button:
• If you have set
drains the water and spins.
• If you have set
only drains the water.
The option indicator
while the indicator
goes off.
3. When the programme is completed
and the door locked indicator
goes off, you can open the door.
4. Press the Aan /Uit - Marche/Arrêt
button a few seconds to deactivate
the appliance.
In any case, the appliance
empties the water out
automatically after
approximately 18 hours.
12.15 Stand-by option
The Stand-by function automatically
deactivates the appliance to decrease
the energy consumption when:
• You do not use the appliance for 5
minutes before you touch the Start/
Pauze - Départ/Pause button.
Press the button Aan /Uit - Marche/
Arrêt to activate the appliance again.
ENGLISH
29
or
and the
. The
, the appliance
, the appliance
or
goes out,
flashes and then
Advertisement
Table of Contents
