Crosley CW-2 Use & Care Manual page 5

WASH/RINSE
TEMPS
These settings feature automatic
temperature control.
ATC Warm/Warm Assures warm water wash
temperature of 95
ATC Warm/Cold optimum cleaning results.
Assures cold water wash
ATC Cold/Cold temperature of 75
activate detergent
Note
• In wash water temperatures below 65
detergents do not dissolve well or clean well.
STEP 5
Select Cycle
To select a cycle, push the control dial IN and turn it to
the right (clockwise) until the pointer is at the number
of minutes desired for the wash load.
Regular/Delicates Cycle
Regular/Delicates cycles share the same portion of the
control dial. For regular fabrics, select the cycle and
turn the Wash/Spin Speed dial to Normal/Normal. For
delicate loads, select Slow/Slow.
LOAD TYPE
°
F. Provides
°
F to properly
°
F,
Wrinkle Free Fabrics Cycle
This cycle provides up to 12 minutes of agitation.
Depending on the load, select either the Normal/Slow
or Slow/Slow wash/spin speed.
Stain Cleaner Cycle
Stain Cleaner provides approximately 30 minutes of
agitation and soaking to help remove stubborn dirt and
stains. For more information see page 6.
STEP 6
Select Extra Rinse
(select models)
When the switch is in the "On" position, an additional
rinse at the end of the Regular cycle is provided to
more completely remove laundry additives, suds,
perfumes, etc.
STEP 7
Pull Control Dial Out to Start
You may stop the washer at any time by simply
pushing the control dial IN. Therefore it is possible to
obtain a non-agitated soak or to shorten, skip or
repeat any part of a cycle. The control dial must be
pushed IN (off position) when you change the setting.
Note
• Do not attempt to turn the control dial
counterclockwise. Damage to the timer will result.
(if desired)
4