Table of Contents
Advertisement
Installation
1. Push grommet and power cord wires into strain
relief in control board (18).
18
Grommet
2. Connect power cord connectors to terminals indi-
cated on control board (18).
18
Route power cord (19) between coupled hose (42)
to filter manifold and sprayer frame.
Bottom View of Sprayer
311990F
Strain
Relief
ti6122a
120V
C
ti9132a
ti9153a
3. Slide control board into place on side of motor front
endbell.
4. Replace three screws (11). Torque to 30-35 in-lb
(3.4-3.9 N.m).
18
5. Connect motor connector (D) and pressure control
assembly connector (A).
6. Install shroud (12) with screw (13). Install front cover
(32) with two screws (11). (see illustration, page 15).
42
7. Install toolbox (3) with two screws (5) (190
Series A).
8. Install kick stand (66) (210
19
Control Board Replacement
18
11
ti9154a
D
A
120V
, 210
ES
Series A).
ES
ti9132a
ES
19
Advertisement
Table of Contents
