Panasonic LUMIX DC-GH5S Operating Instructions For Advanced Features page 353

12. Others
[Unable to record AVCHD video. The selected system frequency does not match
the AVCHD data on this SD card. Please use another SD card or change the system
frequency.]
• If you continue to use the same card after changing [System Frequency] (P259), motion
pictures may not be recorded. To record with the same card, reset [System Frequency] to the
original setting. To record motion pictures with the current setting, try the following:
– Perform formatting
– Insert a different card.
[Recording was cancelled due to the limitation of the writing speed of the card]
• Depending on the [Rec Format] and [Rec Quality] of a motion picture, the speed class rating
required for the card differs. 4K photo recording requires a card that meets a particular speed
class rating. Use a card that meets the rating.
• If the recording stops even when you are using a card that meets the speed class rating, the
data writing speed is too slow. We recommend making a backup and then format the card
(P30).
Depending on the type of the card, recording may stop in the middle.
[A folder cannot be created]
• A folder cannot be created because there are no remaining folder numbers that can be used.
Format the card on this unit after saving necessary data on a PC etc.
If you execute [No.Reset] in the [Setup] menu after formatting, the folder number is reset to
100. (P263)
[This battery cannot be used]
• Use a genuine Panasonic battery. If this message is displayed even when a genuine
Panasonic battery is used, contact the dealer or Panasonic.
• If the battery terminal is dirty, clean it and remove any objects.
[Failed to connect wireless access point]/[Connection failed]/[No destination
found]
• The wireless access point information set on this unit is wrong.
Check the authentication type and encryption key.
• Radio waves from other devices may block the connection to a wireless access point.
Check the status of other devices that are connected to the wireless access point as well as
the status of other wireless devices.
(P30) on this unit after saving necessary data on a PC, etc.
(P28)
(P322)
353
(P30)