Euro-Pro Shark CORDLESS V1900C Manual
  1. Manuals
  2. Brands
  3. Euro-Pro Manuals
  4. Blower
  5. Shark CORDLESS V1900C
  6. Manual
Euro-Pro Shark CORDLESS V1900C Manual

Euro-Pro Shark CORDLESS V1900C Manual

Cordless sweeper
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Cordless Sweeper
Modelo:
Model/
7.2 Volt DC – 7,2 Voltios CC
To Maximize the life of your NiCd batteries:
1. Charge for a minimum of 20 hours before initial use.
Failure to do so will reduce the product's battery life
significantly.
2. Do not store unit with the charging adapter attached
and plugged in.
3. Only recharge when the batteries are fully discharged
(or as close to fully discharged as possible).
4. Do not store in areas of high temperature or humidity.
5. After 3 months of non-use, the product should be fully
discharged and then recharged to maximize battery
power.
6. Use only the charger supplied with the product. If other
chargers are used, the batteries can fail causing damage to
the battery, product, or personal property.
NiCd batteries have a long useful life but at some time they
will need to be replaced. To purchase replacement batteries,
visit www.sharkvac.com.
Note: 1. The On/Off switch must be in the "Off" position in
order to charge the unit. If the charging indicator
does not light, depress the On/Off switch once.
2. If the product has never been used or has been
stored for an extended period of time without use – it
will take several complete charge and discharge
cycles to realize the full operational time of your
product.
Copyright © EURO-PRO OPERATING LLC 2007
V1900C

Advertisement

Table of Contents
loading

Related Manuals for Euro-Pro Shark CORDLESS V1900C

Summary of Contents for Euro-Pro Shark CORDLESS V1900C

  • Page 1 2. If the product has never been used or has been stored for an extended period of time without use – it will take several complete charge and discharge cycles to realize the full operational time of your product. Copyright © EURO-PRO OPERATING LLC 2007...

  • Page 3: Important Safeguards

    IMPORTANT SAFEGUARDS When using an electrical appliance, basic safety precautions should always be observed, including the following READ ALL INSTRUCTIONS BEFORE USING YOUR CORDLESS SWEEPER. WARNING To reduce the risk of fire, electrical shock, or injury: Do not charge this unit outdoors. Do not use outdoors or on wet surfaces.
  • Page 4 PARTS AND COMPONENTS Handle Release Upper Handle Forward Folding Hinge No Touch Empty Button Charging Light Indicator On/Off Switch Charging Adapter: Only Use Kuantech KA12D120015023U Charging Jack Transparent Brush Cover 10. Rotating Brush 11. Edging Tool 12. Gear Box 13. Sweeper Power Head 14.
  • Page 5 OPERATING INSTRUCTIONS Assembling Your Cordless Sweeper Your cordless sweeper will require very little assembly. You should remove it from the carton and familiarize yourself with all the components listed per the exploded view drawing. (Pg. 2) This will help you in the assembly and operation of your cordless sweeper.

  • Page 6: Charging Instructions

    OPERATING INSTRUCTIONS Charging Instructions 1. Connect the charger plug to the charging jack or hole on the side of the sweeper. Plug the charging adapter into the wall outlet. (120V., 60Hz.) Use only charger Kuantech KA12D120015023U. (Fig. 3) Charging Light Indicator Fig.

  • Page 7: Battery Removal & Disposal

    OPERATING INSTRUCTIONS To Maximize The Life Of Your Ni-Cd Batteries 1. Charge for a minimum of 20 hours before initial use. Failure to do so will reduce the product’s battery life significantly. 2. Do not store the unit with the charging adaptor attached and plugged in. 3.
  • Page 8 OPERATING INSTRUCTIONS 4. Carefully lift out the battery pack and disconnect the wire terminals by pulling apart the wire terminal connectors. Remove the battery pack from the unit. (Fig. 6) Wire Terminal Connector Fig. 6 5. Connect the wire terminal connector from the unit to the wire terminal connector of the new battery pack, and replace the battery pack into the unit.
  • Page 9 OPERATING INSTRUCTIONS 3. To release the handle to a comfortable position, gently apply pressure to the top of the sweeper head with your foot while pulling back on the handle. (Fig. 8) Fig. 8 4. To change the speed of the sweeper, press on the speed control button. As you press on it, the speed indicator light will change.

  • Page 10: Cleaning The Dust Container

    OPERATING INSTRUCTIONS Cleaning The Dust Container To achieve the best performance, empty the dust container after each use. 1. Press the dust cup release lever with your foot. (Fig. 11) Note : Be careful not to accidentally turn the unit “On” Fig.
  • Page 11 OPERATING INSTRUCTIONS Changing The Rotating Brush, Gear Box & Squeegee 1. Remove the extension tube handle from the sweeper power head. 2. Turn the sweeper power head upside down being careful not to accidentally turn the unit “On”. Remove the brush cover. 4.

  • Page 12: Changing The Belt

    OPERATING INSTRUCTIONS Slip the belt over the brush bar cap. Insert the brush bar into the slot. (Fig. 16) 10. Insert the gear box tabs into the tab slots and push down until it clicks into place. 11. To replace the squeegee, follow instructions above for removing the gear box and slide the squeegee out from left to right.

  • Page 13: Troubleshooting Guide

    OPERATING INSTRUCTIONS TROUBLESHOOTING GUIDE PROBLEM POSSIBLE REASON POSSIBLE SOLUTION Charge unit. Check fuse or breaker. Batteries discharged. Replace fuse/reset breaker. No power in electrical Call Customer Service at outlet supplying charging 1 (800) 798-7398. SWEEPER WILL Ensure that the wire terminal adapter.

  • Page 14: One (1) Year Limited Warranty

    The liability of EURO-PRO Operating LLC is limited solely to the cost of the repair or replacement of the unit at our option. This warranty does not cover normal wear of parts and does not apply to any unit that has been tampered with or used for commercial purposes.

Table of Contents