Table of Contents
Advertisement
Embroidering preparation
Overview Embroidery functions
1
2
3
Center the needle to the embroidery hoop
Relocating the embroidery hoop facilitates threading when the needle is close to the embroidery hoop.
> Tap «Hoop Indicator/Select Hoop».
> Tap «Center Embroidery Hoop to Needle».
> Thread the upper thread.
P
> To move the hoop back to its previous position, push the button «Start/Stop».
Moving the hoop to the back
To facilitate changing the bobbin, it is recommended to move the hoop to the back before threading. This
makes it easier to open the bobbin cover.
> Tap «Hoop Indicator/Select Hoop».
> Tap «Move Hoop to the Back».
> Thread the bobbin thread. (see page 46)
P
> To move the hoop back to its previous position, push the button «Start/Stop». If necessary, pull back the
Moving the module for the sewing mode
The embroidery module can be positioned so that any sewing projects can be carried out even if the module
is connected.
> Tap «Hoop Indicator/Select Hoop».
> Remove the embroidery hoop.
144
«Center Embroidery Hoop to Needle»
«Move Hoop to the Back»
«Move Hoop to the Left»
upper thread.
1
2
3
4
5
6
4
«Grid On/Off»
5
«Center Motif»
6
«Virtual Positioning»
(becomes visible by scrolling)
Advertisement
Table of Contents
