Header; Connecting Multiple Engineer Remotes To An Engineer; Checking Proper Connection - Martin Audio Engineer 418 User Manual

3.18 Header

The Engineer Remote features a Wago terminal block 6-way header for the connection of the CAT5 cable. To
connect the cable to the header, strip the wires 7mm, use a small flathead screwdriver to firmly press down one
of the header pins, put the wire in the appropriate header hole and release the screwdriver. Do not press down
on two or more header pins at the same time; this may result in damage to the Engineer Remote.

3.19 Connecting multiple Engineer Remotes to an Engineer

With the use of the Engineer Remote Spider, it is possible to connect up to 4 Engineer Remotes to one Martin
Audio Engineer 418 or Martin Audio Engineer 818. For details please refer to the Martin Audio Engineer
Remote Spider manual.

3.20 Checking proper connection

If the Engineer Remote is powered by the Martin Audio Engineer, the backlight of the Engineer Remote will be
lit.
If the Engineer Remote is properly connected to the Martin Audio Engineer 418 or Martin Audio Engineer 818,
and one or more presets have been stored on a Martin Audio Engineer 418 or Martin Audio Engineer 818 with
the Engineer Windows® PC software, the display will show the name of the presets stored in the connected
Martin Audio Engineer 418 or Martin Audio Engineer 818 when pressing one of the 'Preset' up/down arrows on
the Engineer Remote.
For further details please refer to the software manual.
ENGINEERHARDWAREMANUAL1.1[1].doc 28