Table of Contents
Advertisement
v Do not place other machine-readable labels on other surfaces of the cartridge.
Handling Cartridges
Attention: Do not insert a damaged tape cartridge into the drive. A damaged
cartridge can interfere with the reliability of a drive and may void the warranties
of the drive and the cartridge. Before inserting a tape cartridge, inspect the
cartridge case, cartridge door, and write-protect switch for breaks.
Incorrect handling or an incorrect environment can damage cartridges or their
magnetic tape. To avoid damage to your tape cartridges and to ensure the
continued high reliability of your IBM LTO Ultrium Tape Drives, use the following
guidelines.
Provide Training
v Post procedures that describe proper media handling in places where people
v Ensure that anyone who handles tape has been properly trained in handling and
v Ensure that any service or contract personnel who perform archiving are
v Include media-handling procedures as part of any services contract.
v Define and make personnel aware of data recovery procedures.
Provide Proper Acclimation and Environmental Conditions
v Before using a cartridge, let it acclimate to the normal operating environment for
v Ensure that all surfaces of a cartridge are dry before inserting it.
v Do not expose the cartridge to moisture or direct sunlight.
v Do not expose recorded or blank cartridges to stray magnetic fields of greater
v Maintain the conditions that are described in "Environmental and Shipping
Perform a Thorough Inspection
After purchasing a cartridge and before using it, perform the following steps:
v Inspect the cartridge's packaging to determine potential rough handling.
v When inspecting a cartridge, open only the cartridge door. Do not open any
v Inspect the cartridge for damage before using or storing it.
v Inspect the rear of the cartridge (the part that loads first into the tape load
They may interfere with the ability of the drive to load the cartridge.
gather.
shipping procedures. This includes operators, users, programmers, archival
services, and shipping personnel.
properly trained in media-handling procedures.
1 hour. If condensation is visible on the cartridge, wait an additional hour.
than 100 oersteds (for example, terminals, motors, video equipment, X-ray
equipment, or fields that exist near high-current cables or power supplies). Such
exposure can cause the loss of recorded data or make the blank cartridge
unusable.
Specifications for Tape Cartridges" on page 4-10.
other part of the cartridge case. The upper and lower parts of the case are held
together with screws; separating them destroys the usefulness of the cartridge.
compartment) and ensure that there are no gaps in the seam of the cartridge
case (see 1 in Figure 4-4 on page 4-8 and 4 in Figure D-2 on page D-2). If
there are gaps in the seam (see Figure 4-4 on page 4-8), the leader pin may be
Chapter 4. Using Ultrium Media
4-7
Advertisement
Table of Contents
