Table of Contents
Advertisement
Before requesting service for this unit, check the table below for a possible cause of the problem you are experiencing.
Some simple checks or a minor adjustment on your part may eliminate the problem and restore proper operation.
Symptom
The power does not turn on.
The unit turns on automatically
without any operation.
The OSD language menu appears
every time the power turns on.
The unit does not function.
No picture, sound or menu appears on
the screen.
Clock setting and channel setting
cannot be performed.
The unit does not operate properly.
The disc tray cannot be opened.
Playback image freezes for a second.
"Repairing" appears on the TV screen.
Repairing
In a case you intend to cancel the
repairing process.
Do you want to cancel a repairing
process? When selecting "Yes",
the disc may not be usable.
Yes
Repairing
The clock display does not appear in
the front panel display.
When you forget the password for
parental lock.
No analog TV closed captions are
output.
DV signal cannot be input.
The DVC cannot be operated with this
unit.
114 EN
114 EN
E2H42UD_DVDR3576H-37_EN.indd 114
E2H42UD_DVDR3576H-37_EN.indd 114
TROUBLESHOOTING
Remedy
• Check that the AC power cord is connected securely.
• Batteries of the remote control are weak.
• The unit turns on automatically 2 seconds before the timer recording.
• Finish up the language setting procedure by selecting a language in the
OSD language menu. Press [OK] to activate the setting.
• " " or error message appears if the operation is prohibited.
• Batteries of the remote control are weak or exhausted.
• Check if the connections are made securely and correctly.
• Check if the cables are damaged.
• Check if a correct external input channel is selected on your TV. (Refer to
page 21.)
• Check if you have completed the channel setting. (Refer to pages 27 to 29.)
• If a recording is in progress, these operations cannot be performed.
• Moisture has condensed inside the unit. Remove the disc and leave the
unit turned on for about 2 hours until the moisture evaporates. (Refer to
page 5.)
• Check the external input channel. In USB mode, you cannot open the
disc tray.
• During the playback of 2 layered disc, picture may freeze for a moment
when the 1st layer switches to the 2nd layer. This is not a malfunction.
• If there is a power failure or unplugging during recording, finalizing,
formatting or editing (even after "Repairing" disappears), a repairing
process will begin automatically just after turning the unit on again.
It may take several minutes up to about several hours.
• If you intend to cancel the repairing process, press [OPEN/CLOSE A]
on the front panel, then select "Yes" and press [OK]. After that, press
[OPEN/CLOSE A] to take out the disc. The disc canceled during the
repairing process MAY NOT work.
No
• Check that the AC power cord is connected securely.
• (In case of power failure) Check the breaker and clock setting.
• Please cancel the password and the set level. (Refer to page 104.)
• If you are using HDMI connection to watch the TV programs through
this unit's tuner, analog TV closed caption cannot be output. Try using
other connection.
• Before connection, turn on the power supplies for both this unit and the
DVC, and make sure that these units have stopped.
• Only a "DVC-SD" signal can be input from the DVC to this unit. Other
types of signals are not supported.
• Do not connect any device other than the DVC. Even if a recorder or PC
with another DV terminal is connected, the DV function will not operate.
• If the DVC is not recognized after connection, turn off the power supply
for the unit and re-connect the DVC.
• Signal input or DVC operation from this unit may be disabled
depending on the type of DVC.
• If a DVC signal cannot be input, use an external input (E1/E2) for analog
connection via audio/video cables.
• DVC control may be disabled depending on the type of DVC, even in a
mode other than camera mode. In this case, switch to DVD control and
execute the normal recording procedure while operating the DVC.
2007/12/28 11:16:32
2007/12/28 11:16:32
Advertisement
Table of Contents
