Perkins 4016-61TRS1 Operation And Maintenance Manual page 64

64
Maintenance Section
Engine Oil Filter (Auxiliary) - Change
2. Replace the sealing washer, if necessary. Install
the drain plug. Tighten the plug to 68 N·m
(50 lb ft).
Illustration 44
Typical example
3. Replace the engine oil filters (3). Refer to
Operation and Maintenance Manual, "Engine Oil
Filter - Change or Engine Oil Filter (Auxiliary) -
Change" in order to change the engine oil filter.
Illustration 45
Typical example
4. Remove the filler cap (1). Fill the engine with the
required amount of engine oil. Refer to Operation
and Maintenance Manual, "Refill Capacities".
5. Check the oil gauge (dipstick) (2). Ensure that the
engine oil is on the correct mark.
6. Operate the engine and check for engine oil leaks.
Stop the engine. Check the engine oil level. Add
engine oil, if necessary. Refer to Operation and
Maintenance Manual, "Engine Oil Level - Check".
Engine Oil Filter (Auxiliary) -
Change
Note: Refer to the Operation and Maintenance
Manual, "Engine Oil Sample - Obtain" before
performing maintenance.
Change the Filter with the Engine
in Operation
g01441987
Hot oil and hot components can cause personal
injury. Do not allow hot oil or hot components to
contact the skin.
Illustration 46
g01441988
Typical example
The changeover valve (1) has three positions.
• (A) The oil flow is to both oil filters.
SEBU8430-02
i02888172
g01233078