Table of Contents
Advertisement
SEBU8430-02
• Voltage
• Duration of the spark
• Ignition timing
• Level of energy of the ignition
All 4016TRS gas engines are equipped with a device
to detect detonation which is connected directly into
the ignition system. This device automatically retards
the ignition timing.
The ignition timing is retarded when excessive
detonation is sensed. If detonation continues after full
retardation, then the engine must be shut down.
Lubrication System
The engine lubrication oil is supplied by a pump that
is driven by a gear. The oil is cooled and the oil is
filtered. A bypass valve provides unrestricted flow of
lubrication oil to the engine parts if the oil filter
elements become plugged. The bypass valve will
open if the oil filter differential pressure reaches
34.4 to 48.2 kPa (5 to 7 psi). The engine oil pressure
operates in a range of 415 to 450 kPa (60 to 65 psi).
Note: The engine lubrication oil is not filtered when
the bypass valve is open. Do not allow the engine to
operate when the bypass valve is open. This can
damage the engine components.
Cooling System
The water enters the engine from the oil cooler and
the water is passed through the cylinder block. The
water exits the cylinder head into the rail. The water
exits the engine from the water outlet.
Electrounit
This type of engine is supplied with the following
components:
• Jacket water coolant pump
• Water temperature regulator (thermostat)
• Coolant pipe for the charge cooler
• A water pump for the charge cooler
• A water temperature regulator (thermostat) that
controls the water inlet temperature for the charge
cooler
• Battery charging alternator
The system is used when recovery of heat is not an
important factor.
Cogeneration engine
Cogeneration uses energy from heat which would
otherwise be wasted.
The following items are not supplied:
• Water pumps
• Water temperature regulator ( thermostat)
• All water tube assemblies
This system is the responsibility of the OEM.
Engine Service Life
Engine efficiency and maximum utilization of engine
performance depend on adherence to proper
operation and maintenance recommendations. This
includes the use of recommended lubricants, fuels,
and coolants.
For the engine maintenance that is required, refer to
the Operation and Maintenance Manual,
"Maintenance Interval Schedule" in the Maintenance
Section.
Specifications
General Engine Specifications
Illustration 22
Sixteen cylinder
(X) Inlet valves
(Y) Exhaust valves
Product Information Section
Specifications
i02885756
g01210841
23
Advertisement
Table of Contents
