Chassis Fan; Removing The Chassis Fan - Dell OptiPlex 7000 Small Form Factor Service Manual

About this task
The following images indicate the location of the optional I/O module and provide a visual representation of the installation
procedure.
Steps
1. Using a screwdriver, remove the bracket covering the I/O module slot.
NOTE: This step is only for systems that are being upgraded with the I/O module for the first time.
2. Connect the I/O-module cable to the connector on the system board.
3. Insert the optional I/O module into its slot on the chassis.
4. Install the two screws to secure the I/O module to the chassis.
Next steps
1. Install the heat-sink and fan
2. Install the side cover.
3. Follow the procedure in

Chassis fan

Removing the chassis fan

Prerequisites
1. Follow the procedure in
assembly.
after working inside your
before working inside your
computer.
computer.
Removing and installing components 65