Steps
1. Align and place the SMA cable connector on the chassis.
2. Route the SMA cable under the PCIe x16 slot.
3. Insert the SMA cable to the securing clip on the system board.
4. Route the SMA cable assembly through the slot on the rear I/O.
5. Replace the washer and nuts that secure the SMA cable connector to the chassis.
Next steps
1. Install the
wireless
card.
2. Install the
single-graphics
3. Install the
left-side
cover.
4. Follow the procedure in
Rear-chassis fan
Removing the rear-chassis fan
Prerequisites
1. Follow the procedure in
2. Remove the
left-side
About this task
The following images indicate the location of the rear-chassis fan and provide a visual representation of the removal procedure.
76
Removing and installing components
card.
After working inside your
Before working inside your
cover.
computer.
computer.