DeWalt DW088 Original Instructions Manual page 40

EnGLIsh
• Align the magnets
• To remove the drop ceiling bracket, pull the drop ceiling bracket from the tool applying
sufficient force.
to fit the drop ceiling bracket to wall track, proceed as follows (Fig. C3):
• Open the clamp jaws
• Place the clamp jaw around the wall track and release the clamp to close the clamp
jaws shut on the track.
to mount the drop ceiling bracket to a wall, proceed as follows (Fig. C4):
• Hold the tool at the desired position against the wall and mark the location of the
mounting hole on the wall.
• Drill a hole at the marked location.
• Insert a corresponding plug into the hole.
• Hold the tool in front of the plug.
• Turn a screw into the mounting hole
Adjusting the Tool
• To initiate the leveling procedure, switch on the tool. The level and/or plumb orientation
is correctly adjusted as long as the laser beams remain on.
• The laser beams start flashing to indicate that the tool has been set up at a slope that is
beyond the self-leveling range of 4°. Switch the tool off, re-adjust the tool set-up within
the self-leveling range and switch the tool on again.
Aligning the Laser Line (Fig. D)
Align the laser line of either one of the laser beams with the position mark. Move the tool
as required.
OPERATION

WARNING! Do not place the laser in a position which may cause anyone to
intentionally or unintentionally stare into the laser beam. Serious eye injury may
result from staring at the beam.
Instructions for Use

WARNING: Always observe the safety instructions and applicable regulations.
• Always mark the center of the laser lines.
• Make sure the tool has been set up securely.
38
15 with the metal plate on the drop ceiling bracket
16 .
17 .
9 .