CREATE PROJECT screen 1
You can make the following settings on this screen.
Project Name: Touch the
open the screen where you can edit the project
name.
The maximum number of characters for project
and folder names is 31. Extra characters are
discarded.
Folder Name: Touch the
a screen where you can change the name of the
first folder.
NOTE
On the 1st FOLDER screens, the maximum number of characters
allowed is indicated by the yellow background.
Fs: Set that sampling frequency of the project.
48k-0.1% sampling frequency is pull-down
compatible, and 48k+0.1% is pull-up compatible.
BWF Chunk Fs: Set the sampling frequency for BWF
chunks. To use the actual sampling frequency of
the recordings, select
pull-down, select
Fake Rate
48k±0.1%.
NEXT: Open the next page.
CREATE PROJECT screen 2
You can make the following settings on this screen.
Frame Type: Set the time code frame type.
OTHERS: Use the
Current Settings
parameters to create a project or select
to use the default settings.
Preset
3 After you complete making the settings, touch the
button.
CREATE PROJECT
NOTE
If a project with the same project name already exists, the CREATE
PROJECT button appears gray and you will not be able to create a
new project. If this happens change the project name.
button to
Project Name
button to open
Folder Name
. For pull-up/
Actual Rate
to write 48k instead of
of other
Factory
4 Touch the
button when the confirmation pop-up
OK
message appears.
When creation of the project completes, the Home
Screen reopens.
NOTE
Immediately after creation, the new project becomes the
•
current (loaded) project.
The letter "C" appears on the icon to the left of the name of the
•
current project on the PROJECT screen.
Editing the project name
1 Touch the
Project Name
screen to open the
PROJECT
shown below.
Date button: Touch this button to change the project
name to the date currently set for the unit in a
"yyyy-mm-dd" format.
NOTE
If the same project name or folder name already exists, an
•
underscore ("_") followed by a number that has not been used is
added.
After pressing the "Date" button to change the name to the
•
date, you can further edit the name on this screen.
Project name display area: The input project name is
shown. The maximum number of characters allowed is
indicated by the yellow background.
Character buttons: Use these to input the project name.
BS button: Use this to erase the character to the left of
the cursor.
DEL button: Use this to erase the character to the right of
the cursor.
Shift button: Touch this to switch between numerals and
symbols and uppercase and lowercase Roman letters.
5 – Projects
button on the
CREATE
screen as
PROJECT NAME
35
TASCAM HS-8