Page 1
Instructions ® Dyna-Star HP Vent Valve Kit 332519J Used with the Dyna-Star HP or HF Pump to reduce system pressure and allow injector to reset. For professional use only. Part No.: 77X540 Maximum Working Pressure: 3500 psi (241 bar, 24 MPa) Important Safety Instructions Read all warnings and instructions in this manual and the Dyna-Star HP and HF Pump...
Instructions Instructions Installation Warnings See the Dyna-Star HF and HP Pump Instruction manual Pressure Relief for additional warnings. Follow the Pressure Relief Procedure whenever you see this symbol. SKIN INJECTION HAZARD High-pressure fluid from dispense device, hose leaks, This equipment stays pressurized until pressure is or ruptured components will pierce skin.
Page 3
Instructions Vent Valve Installation 5. Loosen, remove and discard the 3 socket head cap screws (b) from the adapter block (a) (F . 3). Reference numbers used in these instructions corre- spond to Parts included in Kit and are provided on page 5.
Page 4
12. Install other end of cable (d) to solenoid control device. NOTE: • Cable (d) is available from Graco. See Accesso- 9. Install lubrication line to vent valve pump outlet port ries, page 5 for a list of available cables. marked “0” (F .
For the latest information about Graco products, visit www.graco.com. For patent information, see www.graco.com/patents. TO PLACE AN ORDER, contact your Graco distributor or call to identify the nearest distributor. Phone: 612-623-6928 or Toll Free: 1-800-533-9655, Fax: 612-378-3590 All written and visual data contained in this document reflects the latest product information available at the time of publication.