Husqvarna BMP 215 Operator's Manual page 34

Assembly of the scarifying drum
2
1
4
1. M6x20 countersunk head screw
2. Retaining plate
3. Scarifying drum
4. Axle
5. Scarifying cutter
6. Spacer
To replace the scarifying drum
WARNING:
parts are fully stopped.
1. Remove the screws and the washers (A, B) from the
side cover (C).
D
B
A C
34
3
5
6
Make sure that all moving
E
2. Remove the side cover (C).
3. Remove the scarifying drum (D).
4. Clean and lubricate the axle (E).
5. Install the new scarifying drum (D) on the axle (E).
6. Install the side cover (C) on the scarifying drum (D).
7. Install the screws and the washers (A, B).
To examine the scarifying drum
• Examine the scarifying drum for wear. Replace if it is
To replace the scarifying drum on
damaged, refer to
page 34 .
To do a check of the drive belt
1. Remove the bolt for the drive belt cover and remove
the drive belt cover.
2. Make sure that the drive belt does not have
damages or visual defects.
3. Push the drive belt to make sure that the drive belt
has the correct tension.
A
1819 - 002 - 07.04.2022