Table of Contents
Advertisement
5.1
HOW TO ORDER PARTS
To assure receipt of the proper replacement parts, supply
your dealer or distributor with the following information:
A. Model number of equipment.
B. Serial number of model, stamped on nameplate.
Part Number
Description
324014
Decal Black Arrow
324141
Decal Caution Rotating Blades
324509
Decal Cleaning
324548
Decal Ventilation
324346
Decal Caution
324393
Decal – Drip Tray
324803
Decal – Header Panel (Stoelting Logo)
324804
Decal - Header Panel (Stoelting Swirl)
324806
Decal - Header Panel (A & W Logo)
324798
Decal – CLEAN/OFF/SERVE
324125
Decal – Elec. Shock Hazard
C. Part number, part name and quantity needed.
Common part names and numbers are listed in this
manual.
5.2
PUSH TO FREEZE LIGHT/SWITCH
LAMP REPLACEMENT
To change a lamp in the PUSH TO FREEZE switch/light
follow these simple steps:
A. Grasp the lens with your thumb and forefinger and
pull out.
SECTION 5
REPLACEMENT PARTS
B. Remove the faulty lamp by pulling out the lamp puller
Figure 33. Push To Freeze Light/Switch Assembly
C. To install the new lamp, line up the lamp end with the
D. Reinstall the lens by pushing firmly in. When installed
5.3
A. Remove side panel.
21
(See Fig. 33).
receptacle and push fully in.
"PUSH TO" might be right side up.
NOTE
LED light bulbs require correct polarity. If the bulb
does not illuminate, remove the bulb, turn 180°
and replace.
CLEAN-OFF-SERVE ROCKER
SWITCH REPLACEMENT
WARNING
DISCONNECT FREEZER FROM ELECTRICAL
SUPPLY SOURCE BEFORE SERVICING.
Hide quick links:
Advertisement
Table of Contents
