Part Names And Functions - Stanton T.8O Operating Instructions Manual

PART NAMES & FUNCTIONS
1
2
3
4
5
6
2
1) REVERSE
This button is used to reverse the direction of the platter rotation.
2) START/STOP
Press this button to start or stop the platter.
3) STROBE DOTS
The dots around the edge of the platter are used in conjunction with the light located inside the motor ON/OFF
switch. While the platter is in rotation, the dots help to indicate the speed of rotation. The speed is lower than the
displayed speed (33,45,78) when the dots are flowing to the right. It is higher than the displayed speed (33,45,78)
when the dots are flowing to the left. When the strobe is stopped, the platter is rotating at the displayed speed.
4) SLIP MAT
5) CENTER SPINDLE
6) MOTOR ON/OFF SWITCH
As opposed to fully analog turntables, this is not the power switch. This switch only turns on or off the motor.
Rotate clockwise to turn on the motor. The platter will not start spinning until the start/stop button has been
pressed. Rotate counter-clockwise during playback (off position) for a slow winding down effect.
7) PLATTER REVOLUTION SPEEDS (rpm)
33 rpm – Press 33
45 rpm – Press 45
78 rpm – Press 33 and 45 buttons simultaneously.
To return to 33 or 45-rpm play mode, just press the desired button.
7
18 17
8 9
16
15
14
13
12
11
10