Operation; Connections; Specifications; Maintenance - Stanton T.5O Operating Instructions Manual

CONNECTIONS

1. Connect the power cord to the auxiliary power outlet
on the rear panel of your amplifier or receiver or to a
household AC outlet.
2. Connect the unit output terminals to the PHONO jack
of your amplifier or receiver.
Output terminals
L (White)
R (Red)
GND (Spade)

OPERATION

1. Rotate the power dial clockwise to turn on the
power, the speed
strobe-illuminator will light up.
2. Place a record on the slip mat, when playing a
45rpm record with a large center hole, place the
45-rpm adaptor on the center spindle.
3. Set the rotation speed (33/45) to match the record.
4. Remove the stylus protector, release the arm clamp.

MAINTENANCE

For best results & proper care of your equipment use
Stanton Vinyl Cleaner (VC-1) for your records and Stylus
Cleaner Kit for styli (SC-4).
Clean the stylus periodically with a soft brush to
prevent the accumulation of dust.

SPECIFICATIONS

APPLICATION:
This specification applies to the belt drive turntable unit T.50
STANDARD TEST CONDITION:
Ambient Temperature
Relative Humidity
NOTE: Measurements can be carried out between 5 degC to 35 degC and 45% to 85% relative humidity.
TURNTABLE SECTION:
Type
Motor
Driving Method
Speeds
Wow and Flutter
Pitch Controls
Starting Time
Braking Time
Time for Speed Change
Audio Output
Amplifier (Receiver)
>> L Channel
>> R Channel
>> GND
indicator and
20 +/- 2 degC
65% +/- 5%
2-speed full manual
DC motor
Belt drive
33 / and 45rpm
1
3
Less than 0.2% WRMS (JIS WTD) with 33
+/-10%
Less than 1 sec. with 33
Less than 1 sec. with 33
Less than 1 sec. from 33
Less than 1 sec. from 45 to 33
Phono output
NOTE:
Be sure to connect the ground terminal firmly to the
amplifier or receiver.
If this connection is not made or is loose, a power
source "HUM" will result.
5. Press the Start/Stop button, the turntable platter will
the start to rotate.
6. Move the tonearm over the desired groove.
7. When play is finished, move the tonearm to the arm
rest, secure the tonearm with the arm clamp.
8. Press the Start/Stop button to stop the platter
rotating, rotate the power dial to turn off the power.
When the sound becomes distorted or noisy, check
the stylus. If worn out, replace it with a new one.
Any volatile materials such as alcohol, thinner, benzine,
etc., may remove the paint or damage the lustre,
please avoid.
/ rpm
1
3
/ rpm
1
3
/ to 45 rpm.
1
3
/ rpm.
1
3
/ rpm
1
3