Table of Contents
Advertisement
Available languages
Available languages
Symptom
"USB ERROR" = "REMOVE USB" =
"PWR OFF/ON" scrolls on the display.
"NO FILE" appears on the display.
"NOT SUPPORT" appears and track
skips.
"CANNOT PLAY" flashes on the
display. / "NO USB" appears on the
display. / The unit cannot detect the
USB device.
"BT FRONT/ BT REAR" cannot be
selected.
No Bluetooth device is detected.
Pairing cannot be made.
Echo or noise occurs.
Phone sound quality is poor.
The unit does not response when you
tried to copy the phonebook to the unit.
The sound is interrupted or skipped
during playback of a Bluetooth audio
player.
The connected audio player cannot be
controlled.
"VOICE" calling method is not successful. Use "VOICE" calling method in a more quiet environment. / Reduce
"PLEASE CNNT BT ADAPTER" scrolls on
the display.
"ERROR CNNCT" appears on the display. The device is registered but the connection has failed. Use
"ERROR" appears on the display.
Remedy/Cause
An over-current occurs. Turn off, then turn on the unit.
Check whether the selected folder, the connected USB device,
or the iPod/iPhone contains a playable file.
Check whether the track is a playable file format.
Check whether the connected USB device is compatible with this
unit. / Reattach the USB device again.
Check the <SRC SELECT> = <BT AUDIO> setting. (page 23)
Search from the Bluetooth device again. / Reset the unit, then search
from the Bluetooth device again.
Make sure you have entered the same PIN code to both the unit
and target device. / Disconnect the Bluetooth device and try pairing
again.
Adjust the microphone unit's position.
Reduce the distance between the unit and the Bluetooth mobile
phone. / Move the car to a place where you can get a better signal
reception.
You may have tried to copy the same entries (as stored) to the unit.
Press DISP or BACK to exit.
Reduce the distance between the unit and the Bluetooth audio
player. / Disconnect the device connected for Bluetooth Phone. /
Turn off, then turn on the unit. / Connect the player again, when the
sound is not yet restored.
Check whether the connected audio player supports AVRCP (Audio/
Video Remote Control Profile). (Operations depend on the connected
audio player.) / Disconnect and connect the Bluetooth player again.
the distance from the microphone when you speak the name. /
Change the "NR/EC MODE" to "OFF" (page 13), then try again.
Connect the USB Bluetooth Adapter to the unit before you can
perform any operation.
<CONNECT PH/ CONNECT AU> to connect the device again.
Try the operation again. If "ERROR" appears again, check if the device
supports the function you have tried.
Continued...
ENGLISH
25
Advertisement
Table of Contents
