Pc Health Status; Smart Fan Configuration - Gigabyte AMD785G Manual

Yes: Assigns IRQ to PCI VGA card if card requests IRQ.
No: Does not assign IRQ to PCI VGA card even card requests an IRQ.
Palette Snooping
The optional settings are: Enabled; Disabled.
Enable: inform the PCI device that an ISA graphics devices is installed in the system
so the card will function correctly.
PCI IDE Bus Master
The optional settings are: Enabled; Disabled.
Enable: BIOS uses PCI busmastering for reading/writing IDE devices.
Offboard PCI/ISA IDE Card
Some PCI IDE cards may require this to be set to the PCI slot number that is holding
the card.

PC Health Status

This section shows the Status of you CPU, Fan, and Warning for overall system status.
This is only available if there is Hardware Monitor onboard.
CMOS Setup Utility-Copyright(C)1985-2005 American Megatrends. Inc.
PC Health Status

Smart FAN Configuration

H/W Health Function
CPU Temperature:
System Temperature:
CPUFAN Speed:
SYSFAN1 Speed:
SYSFAN2 Speed:
VLDT
VDIMM
Vcore
VNB
 : Move
Enter: Select
F5: Discard Charges
H/W Health Function,
it displays information list below when set as below. The choice is either Enabled or
Disabled.
CPU Temperature/
Speed/SYSFAN2 Speed/VLDT/VDIMM/VCore/VNB
This will show the CPU/ /System voltage chart and FAN Speed, etc.
Smart FAN Configuration
CMOS Setup Utility-Copyright(C)1985-2005 American Megatrends. Inc.
Fan1 Mode Setting
Temperature1 Limit of Hig
Temperature1 Limit of Sec
Temperature1 Limit of Thi
Temperature1 Limit of Low
 : Move
Enter: Select
F5: Discard Charges
PC Health Status
Press Enter
Enabled
59C/138F
40C/104F
2923RPM
N/A
N/A
1.160v
1.599V
1.360v
1.160V
+/-/: Value
F6: Standard Defaults
System Temperature/
Smart FAN Configuration
Auto Fan by Duty
050
040
030
020
+/-/: Value
F6: Standard Defaults
26
F10: Save ESC: Exit
F7: Optimized Defaults
CPUFAN1
Fan Configuration Mode Setting
F10: Save ESC: Exit
F7: Optimized Defaults
Help Item
F1: General Help
Speed /SYSFAN1
Help Item
F1: General Help