Table of Contents
Advertisement
Service Manual
18. Stitch length (Full-step version) --continued--
Adjustment without removing front and rear covers
1. Lay machine on its back and remove cap with small screw driver.
2. Loosen screw (A) with L-shaped 5 mm hex driver.
Turn screw (B) in either direction with minus screw driver and confirm whether adjustment is
correctly done after setting up machine in position. Repeat this process until desired feed
balance is obtained.
* Turn the screw (B) clockwise to adjust reverse stitch
* Turn the screw (B) counter clockwise to adjust forward stitch
B
Original issue
Oct.2012
Page 36/41
Model
One Plus
A
Advertisement
Table of Contents
