Table of Contents
Advertisement
Overview Installation Troubleshooting Contact
Configuring a Wireless Client for WPA
If you enabled WPA and set a PSK Passphrase by
same passphrase (key) on each wireless client. The
•
WPA is enabled on the
•
The client passphrase does not match the
For information about the WPA support in Windows XP, visit:
WPA Wireless Security for Home Networks
Overview of the WPA Wireless Security Update in
Windows XP
You can download the Microsoft Windows XP Support Patch for WPA from
http://www.microsoft.com/downloads/details.aspx?FamilyId=009D8425-CE2B-47A4-ABEC-274845DC9E91&disp
laylang=en.
Caution!
Never provide the PSK Passphrase to anyone who is not authorized to use your WLAN.
Configuring a Wireless Client for WEP
If you enabled WEP and set a key by
you must configure the same WEP key on each wireless client. The
•
Shared Key Authentication is enabled on the
•
The client WEP key does not match the
On a WLAN client equipped with a Motorola wireless adapter, you can enter the WEP Passphrase you set when
you configured the VT2500. For all other wireless adapters, you must enter the 64-bit or 128-bit WEP key
generated by the VT2500.
Caution!
Never provide the WEP key to anyone who is not authorized to use your WLAN.
Configuring a Wireless Client with the Network Name (ESSID)
To distinguish it from other nearby WLANs, you should identify your WLAN with a unique network name (also
known as a network identifier or ESSID). As you configure a wireless client, you will be prompted for the network
identifier, network name, or ESSID; type the same name that appears in the ESSID field on the
NETWORK
page in the
VT2500
not configured yet, see
"Configuring the Wireless Network Name on the
After you specify the network name, many wireless cards or adapters automatically scan for an access point such
as the
VT2500
and the proper channel and data rate. If your card requires you to manually start scanning for an
access point, do so following the instructions in the documentation supplied with the card.
VT2400/VT2500 Series Voice Gateway User Guide
Configuration: Basic
"Configuring WPA on the
VT2500
but not on the client
VT2500
http://www.microsoft.com/WindowsXP/expertzone/columns/
bowman/03july28.asp
http://support.microsoft.com/?kbid=815485
If you need to restore the wireless defaults, click Reset Security
VT2500
VT2500
Setup Program (see
FAQ Specifications Glossary License
Advanced
TCP/IP
VT2500", you must configure the
VT2500
cannot authenticate a client if:
PSK Passphrase
VT2500
cannot authenticate a client if:
but not on the client
WEP key
Wireless > NETWORK
for details). If the network name is
VT2500" to configure it.
Wireless
Defaults.,
Wireless >
105
Advertisement
Table of Contents
