Table of Contents
Advertisement
Address
Default
0F0A
4A
0F0B
08
0F0C
14
0F0D
46
0F0E
28
0F0F
82
0F10
82
0F11
FF
0F12
64
0F13
08
0F14
FF
0F15
0A
Name
InterDigitPulseTime
CalibBreakTime[0]
CalibBreakTime[1]
CalibBreakTime[2]
CalibBreakTime[3]
CalibBreakTime[4]
CalibBreakTime[5]
LineSeizureEndTime
RingTermToU100
RingPatternToU100
AgcUpdateTime
LineSeizureTime
Type
D
Inter-digit time in Pulse mode.
Unit : 10 ms, defaults to 740 ms.
D
Calibrated loop-break time for short
Unit : 10 ms, defaults to 80 ms.
D
Calibrated loop-break time for long
Unit : 10 ms, defaults to 200 ms.
D
Calibrated loop-break time for extra
break
Unit : 10 ms, defaults to 700 ms.
D
Calibrated earth-break time for short
Unit : 10 ms, defaults to 400 ms.
D
Calibrated earth-break time for long
Unit : 10 ms, defaults to 1300 ms.
D
Calibrated earth-break time for extra
break
Unit : 10 ms, defaults to 1300 ms.
D
Line seizure end-time - time after hook
Meter-pulse detection continues during
period of time. 00h or FFh means 10
Unit : 10 ms, defaults to 10 ms.
D
Ring terminate time-out period. This
max time that must elapse between
-voltage bursts before the new ring
is registered as a new incoming call.
Unit: 100 ms. defaults to approx 10
D
Ring pattern timeout. Max. silence
during distinctive ringing. As long
silence period does not exceed this
of time the ring is still considered
counted as one single ring.
Unit : 100 ms. Defaults to 800 ms
Line AGC update time. The period
between each line AGC update. If FFh,
AGC is disabled. If used recommended
value is 64h (1 sec).
Unit : 10ms, min/max: 10/FF, Defaults
disabled.
Line seizure time. The period of time
the PSTN line or the PSTN HW needs
the hook-switch is activated in order
ready. During this period audio is
Only used during outgoing calls or
special-line seizure mode is enabled
6).
Unit : 10 ms, min/max: 01/FF. Defaults
100 ms.
70
Description
Advertisement
Table of Contents
