Burner Chart - Bosch 800 Series Installation Instructions Manual

en-us Conversion to LP gas
Remove the electronics pack from the control panel:
5.
With a flat head screwdriver carefully pry the black
‒
tabs at the front away from the panel one by one,
while lifting up the transparent cover of the electron-
ics pack to disengage the tabs.
When all tabs are unlocked you can lift off the elec-
‒
tronics pack.
3
2
1
Remove the black disks from the valve stems. Make
6.
sure the springs underneath the black disks do not
come off.
Adjust the black T10 star head setting screw with a T10
7.
star head screwdriver. Refer to the burner chart for the
correct setting of the setting screws (M).
→ "Burner chart", Page 16
Use setting for LP Gas. The setting screws must
‒
be tightened properly.
Use setting for natural gas. The setting screws
‒
must finish flush with the fitting.
The dual-flame burner has 2 setting screws.
5.4 Burner chart
Refer to this overview for specifications of the individual burners.
Burner Gas type
cap
Small Natural gas
burner Propane gas
16
Pressure Orifice
in inch
wc
6 77
10 54
Replace the white disks and the electronics pack.
8.
Ensure that the gaskets around the burner bases are in
9.
place.
Reinstall the main top.
10.
Reinstall the control knobs.
11.
Replace all burner bases, burner caps and burner
12.
grates.
Continue the installation procedure from
13.
→ "Connection overview", Page 11
When the installation is complete, verify that the appli-
14.
ance works properly.
→ "Checking the installation", Page 13 .
Note: In the event of damage, the valve must be com-
pletely replaced.
BTU/h kW
3,400 1.00
3,400 1.00
M (valve ad-
justment screw
setting)