Inserting Memory Cards; Acquiring Gps Satellite Signals; Selecting The Gps Source - Garmin ECHOMAP UHD2 5 Series Owner's Manual

Inserting Memory Cards

You can use optional memory cards with the chartplotter. Map cards allow you to view high-resolution satellite
imagery and aerial reference photos of ports, harbors, marinas, and other points of interest. You can use blank
memory cards to record Garmin Quickdraw
transfer data such as waypoints and routes to another compatible chartplotter or a computer, and use the
ActiveCaptain ® app.
This device supports up to a 32 GB microSD memory card, formatted to FAT32 with speed class 4 or higher.
Use of an 8 GB or larger memory card with speed class 10 is recommended.
1 Open the access flap or door
2 Fully insert the memory card
3 Clean and dry the gasket and door.
To prevent corrosion, be sure the memory card, gasket, and door are thoroughly dry before closing the door.
4 Close the door.

Acquiring GPS Satellite Signals

The device may need a clear view of the sky to acquire satellite signals. The time and date are set automatically
based on the GPS position.
1 Turn on the device.
2 Wait while the device locates satellites.
It may take 30 to 60 seconds to acquire satellite signals.
To view the GPS satellite signal strength, select
If the device loses satellite signals, a flashing question mark appears over on the chart.
For more information about GPS, go to garmin.com/aboutGPS. For help acquiring satellite signals, see
device will not acquire GPS signals, page

Selecting the GPS Source

You can select your preferred source for GPS data, if you have more than one GPS source.
1 Select > System > GPS > Source.
2 Select the source for GPS data.
4
Contours mapping, record sonar (with a compatible transducer),
™
on the front of the chartplotter.
.
NOTICE
> System > GPS.
66.
My
Introduction