Table of Contents
Advertisement
9. Press bearing (7) into the housing, using a round
tube of the correct diameter and a hand press.
Secure with shim (13) and snap ring (10).
10. Secure snap ring (11) on input shaft (3) if not al-
ready secure.
11. Place gear (1) through top of housing and align gear
(1) and gear (5) so that gear teeth are a match.
12. While holding gear (1) in place, slide input shaft (3)
through gear (1) and bearing (7). Align splines on
shaft (3) and gear (1).
13. Slide shim (12) over input shaft (3) and press bear-
ing (7) onto input shaft (3), using a round tube of the
correct diameter and a hand press.
14. Slide shim (13) over input shaft (3) and secure with
snap ring (10).
15. Check input shaft end float by moving the input
shaft (3) by hand. If end float is higher than 0.012",
insert shim between input shaft (3) and rear bearing
(7). Repeat until end float is less than 0.012". Check
rotational torque by hand. The torque should be less
than 2.2 lbs-inch.
1. Crown gear
2. Gearbox housing
3. Input shaft
4. Output shaft
5. Gear pinion
6. Bearing
7. Input bearing
8. Protective seal
9. Cotter pin
10. Snap ring
11. Snap ring
12. Shim, 45.3 x 2.5
13. Shim, 70.3 x 84.7
14. Nut
15. Castle nut
16. Shim, 50.3 x 70.3
17. Shim
18. Oil seal (Vertical Shaft)
19. Oil seal (Horizontal Shaft)
20. Cap
MAN1339
( 05/17/22 )
16. Check that the gear backlash is between 0.006" and
17. Press in input oil seal (19), using tube of correct di-
18. Press oil cap (20) on to cover the rear of housing,
19. Place top cover (22) on top of housing and secure
20. Check gearbox housing for leaks by plugging all
21. Remove gearbox from water and dry off with com-
Reinstallation
NOTE: Gearbox is heavy: do not attempt to move with-
out mechanical assistance.
1. Set gearbox on cutter and fasten with bolts and
2. Attach crossbar (Crossbar Installation, page 31).
3
7
12
13
10
20
22. Top cover
23. Cap screw 8mm x 16 (8.8)
24. Dip Stick
25. Cotter Pin
26. Washer
Figure 11. Gearbox
0.016". You should not have to adjust the backlash.
ameter. Be careful not to damage seal lip.
using a tube of the correct diameter.
with six cap screw (23).
holes except one. Apply 4 psi compressed air and
immerse the gearbox in water to verify that there
are no leaks.
pressed air. Add SAE 80W or 90W EP oil to proper
level. Tighten all plugs.
nuts. Torque bolts to 300 lbs-ft.
23
24
22
2
1
11
Dealer Service 27
19
10
13
7
CD5795C
14
17
5
16
6
9
4
25
26
18
8
15
Advertisement
Table of Contents
