Filling The Water Tank - Bissell STEAM MOP SELECT Manual

Operations
WARNING
Never put descaling, aromatic, alcoholic, or detergent products into the steam cleaner, as this may damage it or make it unsafe for use.
Attaching Mop Pads
The mop pad may have already come attached
to the mop head, if not follow steps below.
1. Attach mop pad
a. Set mop head in mop pad, making sure
toggle is located on the back.
b. Tighten mop pad by pulling on elasticcord
while pressing on toggle.

Filling the Water Tank

1. Remove tank by lifting straight up and away
from unit.
2. Unscrew cap at bottom of water tank.
3. Fill water tank with water. For best results,
water should be at room temperature.
4. Replace the cap, tighten until snug.
5. Replace water tank by gently sliding tank into
place.
6. Twist the quick release cord wrap clockwise
to unwrap the power cord completely and
plug into a 220-240 Volt outlet as described
on the Important Safety Instructions, page 2.
7. The indicator light will illuminate when the
steam mop is plugged in.
Before You Clean
• Thoroughly sweep or vacuum floor prior to
cleaning with the steam mop.
• During first use, it may take several seconds
for the Steam Mop to begin steaming. The
water needs to flow through the filter to the
heater. This delay will only occur during initial
use or when using a new filter.
• Using distilled or demineralized water will
maximize the performance of your filter.
• Do not attempt to use your steam mop
without water in the tank.
6 BISSELL.com
1a.
1.
4.
1b.
2.
5.